Specifications | Dimensions | Supply Requirements | Clearance Info. | Accessories
Features
Radiant Emitter Tube System
Vacuum System
- 3" O.D. calorized aluminized steel emitter tube for long life and high radiant efficiency
- 5-year limited warranty on the emitter tube
- Smooth cast iron "U" bend
- Products of combustion are pulled through the combustion chamber for increased radiant efficiency and greater safety
- No draft hoods; totally enclosed combustion chamber
Burner System
- One-piece cast iron burner
- 10-year limited warranty on burner
- Direct outside air for combustion
- 4" O.D. combustion air intake and vent
- Direct spark ignition system with step opening gas valve and 100% Gas Shut-Off Safety Control (pre-purge)
- Monitoring lights for visual diagnosis of maintenance needs
Reflector System
Other
- Highly efficient aluminum reflectors
- Reflector ends are enclosed for maximum radiant heat output and minimum convection loss
- Suitable for horizontal or angle mount up to 45 degrees
- Lower mounting height kit required on heater installations between 6 and 8 feet
- Optional deflector kit for reduced clearances to combustible materials
- Optional decorative grille kit for drop ceiling applications
CB
Series Product Brochure CB
Series Installation & CB
Series Submittal Tube
Heater Accessories |
MODEL |
INPUT |
MINIMUM MOUNTING HEIGHT | TOTAL TUBE LENGTH | OVERALL DIMENSION |
CB20 |
20,000 |
8' |
15' |
9' 3" |
CB30 |
30,000 |
8' |
15' |
9' 3" |
CB40 |
40,000 |
8' |
15' |
9' 3" |
CB50 |
50,000 |
8' | 15' | 9' 3" |
NOTE: The clearances specified above must be maintained to combustibles and other materials that may be damaged by temperatures 90ºF above ambient temperature. Clearances to combustibles are posted on the reflector near the control end of the heater. In locations used for storage of combustible materials where they may be stacked below the heater, NFPA 54 requires that the installer must post signs that will "specify the maximum permissible stacking height to maintain the required clearances from the heater to combustibles".
Deflector Kit
Lower Mounting Kit
The Lower Mounting Kit (Part #43515000) is required when the CB series of infrared tube heaters is installed at mounting heights between 6 ft. and 8 ft. above a finished floor. The Lower Mounting Kit consists of both the Emitter Guard Kit and the Draft Inducer Guard Kit as described below.
1. Emitter Guard Kit
The Emitter Guard Kit (Part #43485000) includes an aluminum decorative grille with side emitter guard holder panels. This item and the Draft Inducer Guard Kit make up the Lower Mounting Kit, which must be used in installations with mounting heights between 6 ft. and 8 ft. This item could be used separately in installations above 8 ft., however, for decorative purposes if desired.
2. Draft Inducer Guard Kit
The Draft Inducer Guard Kit (Part #43486000) is an aluminum shield mounted around the draft inducer (brackets and screws included).This item and the Emitter Guard Kit make up the Lower Mounting Kit, which must be used in installations with mounting heights between 6 ft. and 8 ft.
To request a quote or if you need additional information, please call Space-Ray toll free at 800-438-4936 or send us an email.
Besides this Garage / Residential Infrared gas heating product line, other Space-Ray divisions include: Commercial / Industrial, Poultry & Construction.
| home | about us | products: industrial / poultry / construction / garage | news2use | contact info. | email us | site map |
© 2006 Copyright — Space-Ray, Division of Gas Fired Products, Inc. — Charlotte, North Carolina USA
International Manufacturer of Infrared Radiant Gas Heaters